This installation guide will walk through how to install an Allthenticate Smart Door Reader (ALL IN) with an electromagnetic lock. The Allthenticate ALL IN is to be installed on the inside of the desired door and inside of the building (on the secure side).

If you have any questions, you can comment here directly or email us at [email protected]

System Compatibility

• Supports supplementary legacy Wiegand-based readers

📄 Technical Specifications

Dimensions

In Wall

Depth: 1.3” / 3.3 cm

Width: 2.0” / 5.1 cm

Height: 2.9” / 7.3 cm

Faceplate

Height: 4.6” / 11.7 cm

Width: 2.8” / 7.1 cm

Depth: 0.2” / .5 cm (5 mm)

Power (3 ways to supply power)

Power (AC)

Input: 100-240 VAC (0.55A 50-60Hz)

Output (to strike and reader): 12 VDC 800 mA

Power (PoE)

Input: 12W (min) 65W (recommended) or 1 Amp

Output (to strike and reader): 12 VDC 800 mA

Power (DC)

Input: 12-30 VDC (2A max)

Output (to strike): Equivalent to Input

Output (to Wiegand reader): Equivalent to Input

Passthrough Installation (Dry Contact Relay)

Maximum Power: 24 VDC @ 2A

Setups Supported

• Fail safe
• Fail secure
• Parallel install with existing systems

ℹ️ Overview

The ALL IN is designed to fit inside a standard light switch electrical box and can be powered in various ways (DC, AC, or PoE). So if there is a power source near the door, it’s only a matter of connecting a few wires.

Installation using AC Power (PoE and DC are the same general configuration)

A more detailed diagram can be seen below with the various peripherals attached.

🚪 Installing the Smart Door Reader

There are 3 distinct configurations, which are outlined below: Electric Strike, Electromagnet, and co-existing with a pre-installed Electromagnet